我現在在初學zemax的公差分析，找了一個雙膠合透鏡 N@;?CKU  
@D)al^]x6  

圖片:1.JPG

u~r=)His  
b IH;  
然后添加了默認公差分析，基本沒變 CWf /H)~  
\@-@Y  

圖片:2.jpg

_f
tI*ni:<  
K}2Erm%A@y  
然后運行分析的結果如下： $[9%QQk5<L  
LnFdhrB@x  
Analysis of Tolerances x* DarSk  
t![7uU.W  
File : E:\光學設計資料\zemax練習\f500.ZMX }xKP~h'F  
Title: YSs)HV.8  
Date : TUE JUN 21 2011 !*/*
8re  
7.-V-?i  
Units are Millimeters. k
Hkpx52  
All changes are computed using linear differences. 
|$+3a  

k=2Lo  
Paraxial Focus compensation only. T`/AY?#  
<i
<J^-W  
WARNING: Solves should be removed prior to tolerancing. 2:*w~|6>}5  
Y4%:7mw~=  
Mnemonics: Pih tf4
i  
TFRN: Tolerance on curvature in fringes. f'8kish  
TTHI: Tolerance on thickness. 7t3X)Ah  
TSDX: Tolerance on surface decentering in x. []x#iOnC&  
TSDY: Tolerance on surface decentering in y. +O'3|M  
TSTX: Tolerance on surface tilt in x (degrees). "B8Q:  
TSTY: Tolerance on surface tilt in y (degrees). -_ I_
W&  
TIRR: Tolerance on irregularity (fringes). yhlFFbU  
TIND: Tolerance on Nd index of refraction. Gk967pC  
TEDX: Tolerance on element decentering in x. "
-y-iJ  
TEDY: Tolerance on element decentering in y. Ulhk$CPA  
TETX: Tolerance on element tilt in x (degrees). ~Xr=4V:a+  
TETY: Tolerance on element tilt in y (degrees). JgG$?n\  
$v,dz_O*\  
WARNING: RAY AIMING IS OFF. Very loose tolerances may not be computed accurately. &6DMk-  
M-\Y"]sW  
WARNING: Boundary constraints on compensators will be ignored. XV!6dh!  
X"MB|Ny  
Criterion           : Geometric MTF average S&T at 30.0000 cycles per mm R[Ll59-  
Mode                : Sensitivities bAsYv*t%r  
Sampling            : 2 tv>>l%  
Nominal Criterion   : 0.54403234 %mL-$*  
Test Wavelength     : 0.6328 c