looking into the diagram, it looks it can be that the entrance port is not large enough. You may try this, under the Non-Sequential Component surface, you can set Draw Port = 1, which will enable the display of entrance port, change the semi-diameter of the this surface and you might see the light getting through.
caidao737
2013-07-23 23:20
From ZEMAX kb？
我愛海帶葉
2013-07-24 08:23
hopebox:looking into the diagram, it looks it can be that the entrance port is not large enough. You may try this, under the Non-Sequential Component surface, you can set Draw Port = 1, which will enable the display of entrance port, change the semi-diameter of the th .. (2013-07-23 18:17) +U<.MVOo.
